IM | ClearView Hang on Filters

Inspiring Excellence in Fish Care!

Setting Up cont. Positioning the Filter

Hang the filter on the back wall of the aquarium.

Ensure that the Filter sits level, see Levelling the Filter below.

Position the Filter where it will provide the best circulation. This is usually at the centre of the aquarium.

Fill the Filter Body with water from the aquarium until is begins to spill back into the aquarium.

Starting the Filter

Make sure that your hands and cables are dry. Plug the Filter into a power point and turn the power on.

It may take a few moments for the Filter to start running properly as it expels the air from the Impeller and Pipes.

Place the Dust Cover on the Filter Body.

Adjust the flow to the desired rate, see Flow Control below.

Levelling the Filter The ClearView Filter needs to sit level to function at full capacity. In most cases, it will do so with no adjustment. If not, follow the steps below. ClearView 200-800

ClearView 75 Use the Level Adjuster to change the spacing between the Filter Body and the glass.

If the Filter is not sitting level, a sheet of plastic* or card* can be fitted between the Filter Body and the glass.

*Sold Separately

Adjust the flow with the knob on the top of the Inlet U-Pipe. It is usually better to leave at full flow but if the current is too strong, turn down slightly. Flow Control

7