IM | ReefSys 326 AquaSys 315 Cabinet

Inspiring Excellence in Fish Care!

ReefSys 326 / AquaSys 315 Aquarium Cabinet Assembly What’s in the Box

Please ensure that all parts are present and undamaged before beginning assembly

Panels

Top Base Left Side Right Side Left Door Right Door Back Left Back Centre Back Right Top Brace Support Leg Centre Panel

A B C D E F G H J K L M

A

B

C

D

K

L

F

E

G H J

M

Hardware

20 Pin

4 Hinge

20 Cam

24 Hinge Screw

10 Panel Screw

8 Foot

4 Support Leg Pin

8 Foot Screw

4 Support Leg Cam

Instructions Version:24/1/2024

1

Inspiring Excellence in Fish Care!

Assembly Instructions

Step 1 Screw Pins into locations shown.

Step 2 Attach Left and Right Side panels to Back Left and Back Right panels. Secure with Cams.

x8

x6

D

C

D

C

G J

Step 3 Screw Pins into locations shown.

x12 Step 4 Attach Top Brace to Side assemblies as shown. Secure with Cams.

x2

K

D

C

A

J

G

Back view shown

Using Pin and Cam Connectors

PINS AND CAMS

SUPPORT LEG PINS AND CAMS

2

Inspiring Excellence in Fish Care!

Assembly Instructions cont. Step 5 Attach Top to Back Centre, Top Brace and assemblies from Step 4.

Step 6 Secure all joints with Cams.

x10

A

H

C

D

Step 7 Carefully turn Cabinet over so that it rests on the Top Panel. Place the Centre Panel and secure with Cams.

Step 8 Place and secure Base using Panel Screws. Attach Feet using Foot Screws.

x2

x10 x8 x8

M

B

Upside down front view

Upside down front view

Step 9 Turn Cabinet upright and carefully place the Sump* into position.

When positioning the Sump*, ensure that there is some space around it and that it is far enough back to allow positioning of the Support Leg. Be sure to place the Sump Foam Base* under the Sump*.

*Sump with ReesfSys only.

3

Inspiring Excellence in Fish Care!

Assembly Instructions cont. Step 10 Attach Left and Right Doors with Hinges as shown. x4 x24

Adjusting Hinges

Loosen

E

F

Tighten

Step 11 Place and tighten Support Leg Pins as shown.

Always ensure that the Support Leg is securely in place before filling the aquarium.

x4

NEVER remove the Support Leg unless at least half of the water has been removed from the aquarium. Take care when moving the Sump* that it does not contact any metal fittings. It is strongly recommended that the bottom Support Leg Pins are removed before moving the Sump*. *Sump with ReesfSys only.

Step 12 Fit the Support Leg Cams, see Using Pin and Cam Connectors , page 2. Position the Support Leg behind the Support Leg Pins as shown, then slide it forward into position. Secure the Support Leg Cams at the top and bottom.

L

4