Instruction Manual | 2013054_A1_Aquarium_AquaFlora_19122014

Trouble Shooting

BUBBLES ARE COMING OUT THE OUTLET INTO THE AQUARIUM 1. The water level in the filter is too low. Add sufficient water so that the pump is fully submerged. WATER FLOW INTO THE AQUARIUM HAS DROPPED 1. Pump needs to be cleaned. Refer to maintenance instructions in the supplied pump instruction manual in order to clean the pump impeller and impeller housing. 2. Outlet is blocked. Remove and clean the outlet tube. LIGHT DOES NOT WORK 1. Ensure the light unit is firmly connected to the power supply unit and the switch is in the “on” position. 2. Ensure the power supply unit is connected to the power outlet and the outlet is switched on.

3. Grasp the motor with one hand and prefilter with the other and gently pull apart. 4. Remove the impeller cover to allow access to the impeller. 5. Pull the impeller from the motor and rinse under running water. Use a pipe brush to clean the impeller and the impeller chamber. Rinse all components to remove any debris that has been left. 6. Re-assemble the pump and reconnect it within the filter unit. Ensure your hands are dry, plug the pump in at the power outlet and switch it on.

1

2

3

4

5

6

1. Motor 2. Impeller 3. Impeller Cover 4. Pre Filter 5. Flow Controller 6. Suction Cups

8